This article will list the default username and password of an array of security systems. These login credentials are the one that the recorders/cameras come out of the manufacturing line. If you or someone with access to your system has changed any default values, then the default credentials would no longer apply unless the equipment in question is first ‘reset’.

Acti default username/password
Username: Admin/admin
Password: 12345/123456
IP address: 192. 168.0.100

Arecont Vision default username/password
Arecont does not have a default password , but you can reset it to factory settings. Follow these steps:
1-Access the camera’s web interface by typing the IP in your web browser.
2-Under the Administration or System tab, click on Restore to Factory Default.
3-Once the camera reboots, all settings on the camera will be restored to factory default.

AXIS default username/password
For an old system:
Username: Root
Password: Pass
IP address: 192.168.0.90

The new generation AXIS cameras have a resetting sequence
1-Remove the Ethernet cable.
2-Press and hold the control button and insert the Ethernet cable again while holding the control button.
3-Hold the control button until the amber lights turn on.
4-Then release the button .
5-Wait about 1 minute.
6-When the amber lights turns into the green lights your camera is resetted and your password as well.

BOSCH default username/password
For old models:
Username: service
Password: service
IP address: 192.168.0.1
For new models:
You can reset the camera by pushing the reset button about 7 seconds. Or you can reset the NVR by removing the battery on the mainboard (not recommended, at your own risk).

DAHUA default username/password
Username: admin
Password: admin
IP address: 192.168.1.108

Username: 888888
Password: 888888

GEOVISION default username/password
Username: admin
Password: admin
IP Address: 192.168.1.108

HIKVISION default username/password
For old models (before firmware 5.3.0)
Username: admin
Password: 12345
IP Address: 192.0.0.64

For new models you can reset password via SADP tool. Please click the link below and follow the instructions.

LTS Security default username/password
Username: admin
Password: 12345 or123456
IP Address: 192.0.0.64

LTS equipment is Hikvision reabranded.

Messoa default username/password
Username: admin
Password: 1234 or model number of camera or
IP address: 192.168.1.30

Mobotix default username/password
Username: admin
Password: meinsm

SAMSUNG Techwin default username/password
For old models
Username: admin
Password: 111111 or 1111111

For new models
Username: admin
Password: 4321
IP Address: 192.168.1.200

SONY default username/password
Username: admin
Password: admin
IP Address: 192.168.0.100

Speco default username/password
For old models:
Username: root or admin
Password: root or admin

For new models:
Username: admin
Password: 1234
IP Address: 192.168.1.7

Ubiquiti default username/password
Username: ubnt
Password: ubnt
IP Address: 192.168.1.20

Vivotek default username/password
None . You can choose your own password after setup. If you want to reset it.
1-Press and hold down the reset button for at least 1 minute.
2-Power on the camera until the red light flashes rapidly.
Now your camera is back to factory default without any password.